News
d-diot hub v.3.0
The hub 3.0 is a lot different respect to the previous ones, because now it is a wifi multi-gateway (IR, 433 Mhz, Mysensors) based on ESP8266 and ESP32 modules, independent from the Raspberry Pi.
The hub 3.0 is a lot different respect to the previous ones, because now it is a wifi multi-gateway (IR, 433 Mhz, Mysensors) based on ESP8266 and ESP32 modules, independent from the Raspberry Pi.
With this MySensors node you can turn on/off 3 USB type A ports in a traditional or smart way
With this expansion board you can turn on/off 3 USB type A ports; the power state of each port can be controlled with the dedicated physical push button or in a “smart” way through the Home Assistant WebUI
The 3d-printable case for the Raspberry Pi 3 and the d-diot board v.2.0 is available in thingiverse, so now the d-diot hub v.2.0 is completed.
This 3d-printable battery powered node allows you to check if your plants need water!
This cheap, small, 3d-printable, battery powered node allows you to check if your windows or doors are open or close!
This is the first release fully compatible with the Raspberry Pi 4. The image is also backward compatible with the Raspberry Pi 3
A complete DIY, 3d printable smart mood lamp based on ESP8266 and WS2812B (Neopixel) LEDs