News
d-diot hub v.3.0
The hub 3.0 is a lot different respect to the previous ones, because now it is a wifi multi-gateway (IR, 433 Mhz, Mysensors) based on ESP8266 and ESP32 modules, independent from the Raspberry Pi.
The hub 3.0 is a lot different respect to the previous ones, because now it is a wifi multi-gateway (IR, 433 Mhz, Mysensors) based on ESP8266 and ESP32 modules, independent from the Raspberry Pi.
With this MySensors node you can turn on/off 3 USB type A ports in a traditional or smart way
With this expansion board you can turn on/off 3 USB type A ports; the power state of each port can be controlled with the dedicated physical push button or in a “smart” way through the Home Assistant WebUI
This 3d-printable battery powered node allows you to check if your plants need water!
This cheap, small, 3d-printable, battery powered node allows you to check if your windows or doors are open or close!
This battery powered motion, temperature, humidity and light sensor is a must have!
This PCB is the base to build a MySensors based multi-sensor powered with batteries.
MySensors node with MQ2 gas sensor, RGB lamp and buzzer and 3d printable plastic case!
With this pcb you can build a reliable and compact MySensors node based on Arduino Nano and an NRF24L01 radio module